Welcome to BBN High Strength Steels Factory

EN 10025-6 high strength steel S620QL1 as customers request

The company has allocated special environmental protection facilities for all EN 10025-6 high strength steel S620QL1 pollution sources, strengthened the recycling of waste resources and improved the efficiency of resource utilization. At present, the recovery and utilization rate of solid wastes such as iron slag, steel slag, iron bearing dust, EN 10025-6 high strength steel S620QL1 steel mill scale, environmental protection dust has reached 100%.

ASTM A36 and JIS G3192 steel angle EN 10025-6 high strength steel S620QL1 is one of the most widely used carbon steel section in the construction industry and project. It is a low-cost material and shows the required strength property compared with other steels. It is popular also for its good weld performance, formable, and easy EN 10025-6 high strength steel S620QL1 machining. Galvanizing and other treatment increases its resistance to corrosive environment.

The main characteristics of EN 10025-6 high strength steel S620QL1, 12Cr1MoV alloy steel plate are as follows:Compared with 12CrMoV steel, 12Cr1MoV alloy steel plate has higher oxidation resistance and thermal strength. The creep limit of 12Cr1MoV steel is close to the stress rupture strength, and it has high plasticity under the condition of long-term tension. The process and weldability of 12Cr1MoV steel are good, but it needs to be preheated to 300 ℃ before welding, and stress relief treatment is required after welding.

The wear-resistant plate has the main advantages of high strength and hardness, good toughness, EN 10025-6 high strength steel S620QL1 high tensile strength, good material wear-resistance, long service life and low cost. In order to verify the wear-resistant life of the high wear-resistant composite steel plate applied in the field, the comparative industrial test of EN 10025-6 high strength steel S620QL1 wear-resistant with the ordinary carbon plate was carried out on the reclaimer of Jigang raw material plant, and the effect is good.

Our alloy steel plate and sheets are mainly used for weld fabrication of pressure vessels that require improved notch toughness for lower than ambient temperature service.Width: 1000mm to 4500mmThickness : 5mm to 150mmLength: 3000mm to 18000mmImpact tested 52° CEN 10025-6 high strength steel S620QL1, Supply Condition: As Rolled, Normalized Rolling, Furnace Normalizing, Vacuum Degassing, Simulated Post-Weld Heat Treatment or as per customer requirement.

In addition to quality assurance, service is also important for the competition of steel suppliers. All the after-sales service personnel of the company have received professional training and assessment. The steel products supplied by our company enjoy the life-long quality problem replacement service. In the process of using our steel EN 10025-6 high strength steel S620QL1 products, if there is any problem, just contact us in time, and our after-sales service personnel will look for countermeasures and solve the problem with you as soon as possible.

Tags:

Leave a Message

EN 10025-6 S690QL High Strength Steels