Material EN 10025 S550QL1 high strength steel amse equivalent

The company covers an area of 15,000 square meters and the plant construction area is 10,000 square meters. We have introduced more than 50 sets of advanced EN 10025 S550QL1 high strength steel production equipment, auxiliary equipment and testing equipment at home and abroad, more than 260 employees, more than 20 middle and senior management staff, more than 10 professional and technical personnel, annual production capacity of 100,000 tons. Main products: flat steel, EN 10025 S550QL1 high strength steel steel pipe, steel plate, section steel, steel structure processing parts, etc. We also accept incoming materials and annealing processing.

Cold rolling steel is made of hot rolled coil under recrystallization temperature at room temperature. Cold rolled steel sheet is produced by cold rolling process, which is called cold plate. The thickness of EN 10025 S550QL1 high strength steel, cold rolled sheet is generally between 0.1 mm and 8.0 mm. The thickness and width of cold rolled sheet produced by most factories are less than 4.5 mm. The thickness and width of cold rolled sheet are determined according to the equipment capacity of each factory and market demand.

Main characteristics of 12Cr1MoV Steel: compared with 12CrMoV steel, 12Cr1MoV steel has higher oxidation resistance and thermal strength. The creep limit of 12Cr1MoV steel is very close to the endurance strength value, and it has high plasticity under the condition of endurance tension; the processability and weldability of 12Cr1MoV steel are good, but it needs to be preheated to 300 ℃ before welding, and stress removal treatment after welding. 12Cr1MoV steel is widely used in Superheater, header and main steam pipe of high pressure, ultra-high pressure and subcritical utility boiler.

In the production process of the ironmaking process, the moisture content and air temperature of the ironmaking blast furnace blast have a direct impact on the fuel consumption and fuel consumption structure of the ironmaking process. Blast furnace blast dehumidification is to remove the moisture in the blast furnace blast, eliminate the adverse effects of atmospheric humidity fluctuations on the blast furnace forward movement, and create stable operating conditions for the fans.

A537 grade 70 steel with the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the EN 10025 S550QL1 high strength steel, A537 grade 70 steel coil thickness should not exceed 25 mm. The mechanical properties of A537 grade 70 steel is yield strength is 290MPa, and the tensile strength is 485-620Mpa.

The company specializes in heavy plate cutting, carbon steel pplate processing, carbon plate welding processing and sales of wide and thick steel EN 10025 S550QL1 high strength steel plates. It has high-quality CNC steel plate cutting and processing equipment, a professional technical personnel team, and supporting logistics distribution and after-sales service system. BBN company provides customers with solutions at low prices, high quality, and fast response service.