What harm does the excessive weld height of EN10025 S690QL specs bring

The cold rolling precision bright pipe system produced by our factory has smooth appearance, uniform wall thickness, no oxide layer and high precision. The inner hole of EN10025 S690QL specs steel pipe can be divided into round, spline and plum blossom, which is widely used in automobile, motorcycle, electric power, petrochemical, ship, aerospace, bearing, pneumatic components, oil cylinder, boiler equipment, medical equipment, fitness equipment and other industries. Materials can be divided into: 10#, 20#, 35#, 45#, 40Cr, 16Mn, etc. According to the needs of users, we can make all kinds of national standard non-standard precision pipes. Special EN10025 S690QL specs materials and specifications can be ordered in advance.

AISI4140 steel plate is used to make forgings that require higher strength and larger quenched and tempered section than 35CrMo steel, such as large gears for locomotive traction, turbocharger transmission gears, pressure vessel gears, rear axles, connecting rods with extremely high loads, and Spring clip. It can also be used for oil deep well drill pipe joints and fishing tools below 2000m, and can be used for molds of bending machines.

Different form EN10025 S690QL specs, boiler steel plate is one of the most critical materials in boiler manufacturing. Boiler steel plate mainly refers to the hot-rolled special carbon steel and low alloy heat-resistant steel plate used to manufacture important components such as the shell, drum, header end cover, support and hanger in the boiler. Boiler steel plates are often working under medium, high temperature and high pressure. In addition to withstand higher temperatures and pressures, boiler steel plates are also subject to impact, fatigue loads, and water and gas corrosion, resulting in poor working conditions.

Normalizing is to heat the steel parts to 30~80℃above the critical temperature for a period of time. Then the parts are taken out of the furnace and cooled in air. Since the cooling rate of normalizing is faster than that of annealing, the strength and hardness of normalized EN10025 S690QL specs are higher than that of annealed EN10025 S690QL specs, but the elimination of internal stress is not as good as annealing. The normalizing operation of EN10025 S690QL specs is simple, the cost is low, the productivity is high, and it is widely used in actual production.

A335 P22 steel pipe belongs to ferrite alloy steel nominal pipe for high temperature use. Chemical composition of A335 P22 steel pipe: C 0.10-0.20, Mn 0.30-0.80, P ≤ 0.025, S ≤ 0.025, Si 0.10-0.50, Mo 0.44-0.65. Mechanical properties of A335 P22 steel pipe: tensile strength 415mpa, yield strength 205 MPa. EN10025 S690QL specs, A335 P22 steel pipe is characterized by good process performance, less sensitivity to the heating temperature of heat treatment, good welding performance, good plasticity, and low strength, especially the high temperature rupture strength is lower than 12Cr1MoV steel. When used at the same temperature and stress, its wall thickness is about 30% thicker than 12Cr1MoV Steel.

We should focus on the main problems to be solved and pay attention to efficiency. After receiving the user's quality objection report data, the possible causes, responsible units, compensation amount, etc. of the problem shall be judged based on experience. To have a clear service plan, to be clear about what your main problem is, what technical support is needed, these should be prepared.