Welcome to BBN High Strength Steels Factory

What is the process principle of S550 stainless steel brake lines

Based on the main S550 stainless steel brake lines business of iron and steel, we are committed to producing high-quality, green and efficient steel products. The main steel products are medium and heavy plate, hot rolled coil, section steel, steel tube, etc., which are widely used in automobile, oil, railway, bridge, construction, electricity, transportation, machinery, shipbuilding and other important fields. Our steel S550 stainless steel brake lines products are exported to Indonesia, Bangladesh, Myanmar, Iran, Brazil, Mexico, UAE, Iraq, etc Egypt, Mozambique, Ukraine and other dozens of countries and regions.

After quenching and tempering, the 40Cr alloy steel plate has good comprehensive mechanical properties, good low-temperature impact toughness and low notch sensitivity. The hardenability of steel is good. It can be hardened to Ф28~60mm in water quenching and Ф15~40mm in oil quenching. In addition to quenching and tempering, 40cr sheet is also suitable for cyanidation and high-frequency quenching.

The metallurgical quality of spring steel should reach the level of high quality steel. Due to the special requirements of production parts, S550 stainless steel brake lines, spring steel must have some characteristics. First, the fatigue resistance of spring steel is good, and it can be restored to its original state after repeated use without deformation. Second, good flexibility. Third, the tensile strength of spring steel is good, under the limit of being stretched, it can be restored without breaking.

Low alloy high strength steel is a kind of engineering structural steel developed by adding a small amount of Mn, Si and a small amount of Nb, V, Ti, Al and other alloy elements on the basis of carbon structural steel, S550 stainless steel brake lines. The so-called low alloy means that the total amount of alloying elements in steel is less than 3%. High strength is relative to carbon engineering structural steel. The development principle of low alloy high strength steel is to use as few alloy elements as possible to obtain as high comprehensive mechanical properties as possible, so as to meet the requirements of use and low cost.

DIN 17100 St37-2 steel plate belongs to the carbon and low alloy high strength steel plate. We can supply the different sizes of S550 stainless steel brake lines, DIN 17100 St37-2 steel plate. And the rolling size of DIN 17100 St37-2 steel plate is following: the thickness range is 1.2-600mm, the width range is 1220-4200mm, and the length range is 5000-18000mm. Also note that the DIN 17100 St37-2 steel coil thickness should not exceed 25 mm.

S355J2 hot rolled steel plate executive standard: EN10025-2S355J2 hot rolled steel plate delivery status: control binding, normalizing rolling, normalizingThe European standard S355J2 hot rolled steel plate is available from S550 stainless steel brake lines stock and can be cut and processed according to the requirements of customers; the futures can be produced according to your requirements, and our S355J2 hot rolled steel plate price is preferential and the delivery time is fast, welcome to contact and purchase.

After the order is finished, our after-sales service center will send an email to make a feedback about our steel products' quality. We have phone service every three months to remind our customers of the possible problems and collect advices or suggestions in quality and service. Upon the collection of advices or suggestions, our after-sales service will quickly make technical solutions to wipe out the customer problem.

Tags:

Leave a Message

EN 10025-6 S690QL High Strength Steels